For Tacoma Trailhunter owners
Choose the Trailhunter listing if your Gen 4 truck has the compatible Trailhunter OEM sliders. The order is prepared with Trailhunter-specific collars and clips, so selecting the vehicle-specific listing matters even when step bodies look similar.
Before choosing, compare a side view and an end view of your rail against the listing photographs. If the rail has been replaced, repaired or modified, do not rely on the trim badge to establish fit.
For Tacoma TRD Pro owners
The supported application is the Gen 4 TRD Pro with the compatible accessory OEM double-tubular rock sliders. A TRD Pro badge is not enough: the single-rail standard guard is a different mounting surface.
Use the TRD Pro listing so the order is assembled with the collars and clips for that supported accessory rail. If you are unsure which rail was fitted to your truck, ask for help before selecting a step.
Choose the height separately from construction
For these Toyota steps, Low positions the platform approximately two inches below the High version. Choose Low when a reduced climb into the cab is the priority. High keeps the platform closer to the rail for additional footing and reaching gear.
Standard and Reinforced refer to construction, not height. The current Toyota listings state a 235 lb warranty weight limit for both constructions; Reinforced does not raise that limit. Check the full current product instructions and warranty before use.
Your ordering checklist
- Confirm Gen 4 Tacoma and the actual rail configuration.
- Choose the Trailhunter or TRD Pro application that matches your truck.
- Select High or Low, then the available construction and set quantity.
- Review the product photos, current price and made-to-order conditions.
Interchangeable fitment components do not make these steps universal. Contact ZR2Steps before adapting them to another vehicle.